Now that the drainage areas have been defined, we can define the storage element.
This tutorial will use a trapezoidal pond. If you haven't done so, Press the OK
button in the Basin Dialog to close the drainage area dialog.
Expose the PROTOTYPE record under the Nodes Category and right mouse click on it
to bring up the Node dialog.
|
|
|
When the PROTOTYPE record appears, immediately press the New Node
button and this time change the autolabel to trap. Press OK.
|
|
Change the node type from whatever it is currently set to Trap Pond.
Set the Start El to 100 ft and the Max El to 108 ft. When finished, select the
Trap Pond tab that appeared when the Trap Pond button was selected.
|
Enter the data shown in the trap Pond and press Close
to close the dialog.
|